Well I put a Tors Eleminator kit in a set of customers carbs this weekend and thought I would do a write up for anyone that hasn't done it. Its a very simple mod and will unleash alot of useful power in your shee, make adjustments much easier and clean up the engine area.

First off get all your tools together

Tors eliminator kit. This one is a Vitos and the ones I carry. They also come with a new throttle cable but we didnt need one in this case.




TOOLS


NEXT YOU WILL NEED TO FILE THE HOLE THAT IS UNTAPPED AND THAT HAS A SLIGHT ANGLE TO IT FLAT SO YOUR ADJ. SCREW WILL SEET PROPERLY.

CHOKE SIDE


OTHER SIDE


FILE DONT TAKE TO MUCH OFF JUST MAKE IT EVEN AND SMOOTH.


NO MORE BEVEL



NEXT YOUR GOING TO DRILL THE HOLE BOSS WITH THE PROVIDED DRILL BIT. STUFF A CLOTH AND OR A PIECE WOOD INTO THE CARB SO YOU DONT HIT THE OTHER SIDE AND TO KEEP OUT DEBRIS. A VISE COMES IN REAL HANDY HERE. A DRILL PRESS OR STEADY HAND AND A HAND HELD DRILL WILL WORK. USE SOME CUTTING OIL OR SOME TYPE OF OIL TO LUBRICATE BIT.





THEN USE THE PROVIDED TAP AND TAP THE HOLE BOSS. U CAN USE A CRESENT WRENCH IF YOU DONT HAVE A TAP SET. TAP ALL THE WAY TO TOP OF THE TAP THREADS. DO NOT OVER DO IT BECAUSE YOU CAN BREAK AN EDGE OF THE HOLE BOSS.




NEXT CLEAN UP THE BURS AND BLOW THE CARB OUT WITH AIR AND CLEAN THOROUGHLY.
NOW TIME TO PUT THE IDLE SCREWS IN. THREAD THE NUT ONTO THE SCREW AND THREAD SLOWLY AND EVENLY INTO THE HOLE BOSS.





PUT THE PROVIDED CARB TOPS ON INSTALL BACK ONTO SHEE AND ENJOY YOUR NEW FOUND CHEAP AND EASY POWER.

COST OF TORS KIT. $55 FROM ALFIESTOYBOX

TIME TO INSTALL- 1 HOUR.

SKILL LEVEL- EASY

I hope this helps and will encourage you to do this very simple mod for yourself and not be discouraged.

WILL A MOD OR ADMIN PLEASE STICKY THIS. THANKS.